Standard Parts List - Honeywell E3 Point Manuel D'utilisation

• If a second overload occurs before the system is reset by
pressing and holding ESC for 8 seconds, the E
the overload and pressing ESC may not reset the system. If that
occurs, after the gas overload has been removed, the power
should be turned off and back on to clear the overload. If this
does not work, wait 20 minutes and try again.
WARNING: If the system has latched in Overload, the sensor cartridge may
!
be damaged. Replacement of the cartridge is strongly recommended. At
an absolute minimum, a recalibration should be performed. See
Inspection and

Standard Parts List

 
Item # Description
1 E Point cover
3
2 E Point housing base
3
3 Main sensor assembly
4 Large rectangular J-box (not included)
5 Captive screw 10-32 x ½" (tamper proof screw also available)
E Point Network Gas Monitor User Manual
3
Maintenance.

Figure 7. Parts of the E
Specifications
Standard Parts List
Point may latch
3

Point
3
Periodic

29