Table des Matières
Publicité
Responsibility of the operator:
The machine is designed for professional use. The operator of the machine is therefore subject to
the statutory obligations for occupational health and safety.
Besides the safety notices in these operating instructions, additionally, the national, and generally
valid operation safety and accident prevention are binding.
In this the following applies in particular:
■
The machine is only used by personnel instructed in its handling and authorized to use it.
■
The operator must ensure that the user wears sturdy footwear to prevent injury.
■
The operator must ensure that the recognized occupational safety regulations and all other legal
or company internal provisions are observed.
■
The operator must ensure that all users are acquainted with the safety regulations and trained in
the use of the specific machine.
■
The operator must ensure that responsibilities for the operation, maintenance and repair of the
machine are clearly assigned and observed.
■
The operator must ensure that all users have read and understood the operating instructions
before using the machine.
Furthermore the operator must ensure that the machine is in perfect technical condition.
Therefore following applies:
It is the responsibility of the operator to ensure that the maintenance intervals described in these
■
operating instructions are observed.
The operator must ensure that all safety devices are controlled on function and completeness
■
on a regular bases.
Faults and damage must be immediately notified to the Wetrok Service Agent.
■
Protective guards must not be dismantled nor bypassed.
■
Responsibility of the user:
The machine may only be used by personnel who have been instructed in its handling and
■
authorized to use it.
When leaving the machine, the machine must be secured against unintended motion, and the
■
switch must be switched off. If available, the mains connection must be unplugged.
WARNING
Limiting values
The machine may not be used on surfaces with a slope over 2%. The
specified maximum tilt of the cleaning surfaces may not be exceeded
Air humidity during operation must be between 30-80%.
Vibration level is below 2.5 m/s
.
2
Noise emission is below 65 dB A.
It is permissible to use and store machine within an operating temperature range
of 5°C to 40°C only.
Do not use or store machine outside in wet weather conditions (i.e. rain) or in a
cold environment < 5°C.
Couplings of mains connections must be minimum protective class IP54.
(Spray water protection)
DE
FR
IT
EN
11
Publicité
Table des Matières
