Ice Maker Module - Wessamat CombiLine W80 Manuel De L'utilisateur

User manual - English

7.2 Ice maker module

1. Switch off the machine at the production switch (Aus / Off) and pull out the power plug.
2. Remove cover.
3. Push the housing front panel up and lift off.
4. Completely remove the ice in the storage container. Ice cream intended for consumption
must not come into contact with the cleaning agent.
5. Wet a clean sponge or cloth sufficiently with WESSAMAT special cleaner and wipe out the
vertically positioned tub. Repeat this process several times depending on how dirty it is. Moisten
from time to time during cleaning the sponge or cloth with WESSAMAT special cleaner. Allow the
special cleaner to take effect for a few minutes and clean with a sponge or brush.
6. Rinse the tub with clear water. Use a clean sponge or cloth for this. In the case of extrem
th
dirt, this process (5
7. Dip a sponge or cloth in soapy water and wipe the tub with it to neutralize the special clean-
er
8. Then clean the water level probe. To do this, clean the three vertical sensors from below
with a commercially available sponge to remove any limescale deposits. Please be sure that the
water level probe is dry after cleaning.
User-manual-CombiLine-W80-W120-W240-0299-2
th
-7 ) must be repeated several times.
Seite 57