Battery Installation - RocHobby 1941 MB Scaler Manuel D'utilisation

Removing or replacing the handle
1.Pull the handle release latch.
2.Pull back on the handle to release the handle from the
transmitter itself.
3.To replace the handle, pull back on the handle release
latch and push the handle back onto the transmitter.

Battery installation

This transmitter accepts alkaline or NiMH AA batteries. There is a built in low voltage warning where when the
voltage is lower than 4.5V +/- 0.2, the buzzer will sound continuously and the LED will flash. This is to remind the
user to change the batteries for fresh units.
1. Remove the battery cover from the transmitter.
2. Insert four new AA batteries according to the polari-
ty markings on the battery holder.
3. Reinstall the battery cover.
Warning: do not attempt to charge non-rechargeable batteries,
you may cause an explosion.
Warning: please don't reserve the battery,or it will burn out
the PCB.
06
EN