RocHobby 1941 MB Scaler Manuel D'utilisation page 10

EN
Specifications
Cont. / Burst Current
Vehicles applicable
Motor Limit
Dimension&Weight
ESC setup
Attention: The incorrect polarity will damage the ESC immediately.
1. Connect the ESC, motor, receiver, battery and servo according to the following diagram
Ensure that the + and - wires of the ESC are connected to the battery pack.
The control cable of the ESC is connected to the throttle channel of the ESC (Usually CH2).
The motor + and motor - cables are connected to the motor in any order, if the motor runs in reverse, reverse the cables.
2. Set the Transmitter
Please set the "D/R", "EPA" and "ATL" to 100% for throttle channel (for transmitter without LCD, please turn the
knobs to the maximum value), and set the "TRIM" of the throttle channel to 0 (for transmitter without LCD, please
turn the TRIM knob to its neutral position).
For Futaba TM and the similar transmitters, the direction of throttle channel shall be set to "REV", while other
radio systems shall be set to "NOR". The "Fail Save" function of the radio system is strongly recommended to be
activated. Please make sure that the motor can be stopped when the "Fail Save" happens.
Model
Input
2S Lipo or 5-6 cells NiMH
3S Lipo or 7-9 cells NiMH
Resistance
Built-in BEC
Batter + (Black)
Batter + (Red)
Brushed Motor
WP-1060-BRUSHED
Forward: 60A / 360A
2-3S Lipo, 5-9 Cells NiMH
1:10 on-road, off-road Buggy, Truggy, SCT
540 or 550 size motor ≥ 8T or RPM <45000 @7.2V
540 or 550 size motor ≥13T or RPM <30000 @7.2V
Fwd: 0.0008 Ohm, Bwd: 0.0016 Ohm
3A/6V (Switch mode BEC)
36*30*18, 40g
Servo
To "Throttle" channel
LED
Switch
Motor - (Blue)
09
Backward: 30A / 180A
1:10 Crawlers, Tank &Boat
Receiver