Vehicle Setup; Connecting The Battery - RocHobby 1941 MB Scaler Manuel D'utilisation

Fault
The motor suddenly stops running
while in working state.
The model cannot reach its
maximum speed and the red LED
does not become solid at full
throttle.
Motor is cogging when accelerated
quickly.

VEHICLE SETUP

Connecting the battery

STEP 1: Release the two body clips.
STEP 2: Lift the vehicle body and place the brace rod
between the chassis and body.
STEP 3: Place the battery in the battery box then
connect the battery plug (T-plug or XT60 plug).
Possible Reason
The throttle signal is lost.
Low voltage cut-off protection or
Over-heat cut-off protection has
been activated.
The transmitter is improperly setup.
The battery has limited discharge
ability.
Motor RPM is too high, the gear ratio
is too aggressive.
Something wrong in the driving
system of the car.
12
Drivetrain fault Solution
Check the transmitter and the receiver.
Check the throttle wire connection.
Replace the battery pack, or cool
down the ESC.
Check the settings.
Set D/R, EPA, ATL to 100% or turn the
knobs to maximum value.
Set TRIM to 0 or turn the knob to its
neutral position.
Use battery with better discharge
ability.
Use motor with lower RPM, or use
smaller pinion to get softer gear ratio.
Check the drivetrain of the vehicle.
EN