Commissioning, Use; Version Information - flamco Flamcomat Mode D'emploi Et Installation

3. Commissioning, use

With the expansion module in position, the card inserted and the control-unit cover that allows the power supply and control unit to be switched
"On" in place, menu [11-3-7] gives access to the version view of the following extension:
Service menu [11] » » Version information [11-3] »
[11]
If the version number under [11-3-7] is missing, the module is not ready for operation (see pages 5 and 6 - Internal and external error messages).
Once the module has been initialised (ready for operation), the save function enables the following configuration:
Data transfer [2] » » SD card [2-2] » secure config. on SD [2-2-1] »
[2]
» Carry out action » Enter. The back-up operation does not prevent any control functions relating to pressure. Examples of saved records are shown
on pages 6 and 7.
Location of data in menu:
Menu
Data transfer
Main menu
Order
number
Service
menu
Controller
Version
information
Internal messages; LED displays on the module (no. 1.2 and 1.3);
Status Description
Green "Off" Module not recognised, not available, no access
(version number under [11-3-7] not available).
Green "On" Module recognised.
Green "flashing" Data transfer
Red "Off" No errors.
Red "On" Use of module blocked
(Licensing of headings).
Red "intermittent" Last action resulted in error.
External error message; applicable error message after going to message display on terminal if error message shown:
Display Description
60 Last external module action resulted in error
Extension (identical to LED red, flashing intermittently;
no. 1.3).
Important: Error not saved, not contained in menu
[11-6]
(Error history, analysis).
» slot 2 [11-3-7] »
[11-3]
Menu Menu Menu
Date, time Language Log-in
Equipment Version Commis
menu information sioning
Terminal Forward Loader
[11-3-7]
Configuration Start-up Operation
menu menu menu
Hours of
Maintenance Errorlist operation
Language Slot 1 Slot 2
Action
Control unit, power supply;
use indicated slot; clean contact surfaces of the
connector strip.
Access, function possible.
Do not remove module or SD card!
-
Use module on one of three previously used
control units.
Repeat process under initial conditions (see also:
"External error message",
60 module).
Measures
Acknowledgement deactivates the error message
and the flashing red LED.
(no consequences for not acknowledging)
Repeat process under initial conditions.
Network
Service menu menu
Top-up/
draining
Slot 3 Slot 4
5