Appropriate Use; Equipment, Installation Of Module - flamco Flamcomat Mode D'emploi Et Installation

This document is a supplement to the installation and operating instructions: Flamcomat, doc.-no.: MC00448/06-2013/eng;
Flexcon M-K, doc.-no.: MC00449/06-2013/eng and must be used in conjunction with these basic documents only. The general safety instructions
contained herein apply to the equipment, use and function.
For installation instructions and further documentation in various languages, visit www.flamcogroup.com/manuals.
Further product information can be obtained from the respective Flamco branch office (see page 2).

1. Appropriate use

Electronic components form a licensed addition to an SPCx-lw / hw control unit, to provide an SD / MMC card interface for the requirements of SPC
data transfer. The declaration of conformity in the basic document is applicable.
Use: to process an available SPC configuration file*, save it (to other data carriers), use it for analytical purposes (evaluation, tracing, etc.) or
communications (distribution, forwarding). File use for making changes or for Support / Service to create an identically-configured control unit
subject to specific instructions.
*) For correct use of available or required records in an SPC control unit.

2. Equipment, installation of module

Original equipment: The module is an integral part of the control unit for external pressure (Fig. 1; 2; 6). Supplementary equipment: The packaging
contains item 1 (fig. 3), the actions involved in fig. 2 and 4 - 6 can only be carried out on switching off the power supply.
1. SPC Extension module, SD card
1.1 Version type, back:
"SPC_SD_V(...) . (...)".
1.2 LED green, illuminated (functioning).
1.3 LED red, illuminated (error).
1.4 Connector strip.
1.5 S ecure Digital Memory Card (SD) 2 GB memory card,
alternatively Multimedia Card (MMC) up to 8 GB;
Secure Digital Memory Card High Capacity (SDHC) up
to 32 GB; File formats: FAT12; 16; 32.
1.5.1 Write-protect slide (Lock).
2 SPCx-lw control unit
Figur 1
SPCx-lw
4
Figur 6
SPC expansion module with SD
memory card inserted vertically in
available slot 2 (connector strip in
slot to lock-in position).
Figur 2
SPCx-hw; shown without control unit
cover (removed) and information panel.
Equipment shown: Direct start, 2 motors.
2.1 Information, note: Dangerous voltage! To be opened
by qualified personnel only. Disconnect from power
supply before opening the unit.
3 SPCx-hw control unit
4 SPC Terminal
4.1 S ensor key: "Error message display", active on
backlighting red on.
5 SPCx control unit
5.1 Slots 1...4.
5.2 Predetermined breaking point field
5.3 Breaking point field opening.
5.4 Slot 2.
Figur 3
Figur 5
Remove slot 2 breaking point field
with special tool (remove surplus
material at break point).
Figur 4
SPCx-lw; shown without control unit cover
(removed), information and SPC terminal.
Recessed grip
Legend