Petsafe Drinkwell Platinum Manuel D'utilisation page 9

FOUNTAIN REASSEMBLY
2) Thread the plug through the opening next to the pump. Under
the arch you can tuck the cord into "cord channels" (Fig. 3c),
then move the cord along the back of the fountain to the "cord
pass-through." (Fig. 3d) Use this pass-through to keep the cord
from showing.
3) Line up the filter housing unit over the pump and then the bowl.
You will want to line up the intake tube to fit directly into the
pump. Once in place, gently push down, locking the housing
into place. (Fig. 3e & 3f)
4) Replace the pre-filter over the flow control knob by sliding the
narrow end in first. The lip on the top of the pre-filter should be
facing the front of the fountain, push down to snap it into place.
(Fig. 3g)
5) Replace the filter and the lid.
6) Replace the reservoir.
Fig. 3c
Intake
Tube
Fig. 3e
www.petsafe.net
Cord Pass-Through
Fig. 3d
Fig. 3f
Fig. 3g
9