Petsafe Drinkwell Platinum Manuel D'utilisation page 6

OPERATING INSTRUCTIONS
6) Place fountain in desired location. If placing on carpet, tile or
wood flooring use a protective surface such as a towel or place
mat to protect your floor from splashing or dripping from your
pet.
7) Fill the fountain with water. This includes the bowl and the
housing. This will prime the pump. Replace the lid and snap into
place.
8) Remove the reservoir by lifting up and away from the fountain.
Turn the reservoir upside down and remove the the reservoir
cap. Fill the reservoir with water and replace the cap. Holding
the reservoir upside down and backwards to the fountain (Fig.
1d), quickly turn the reservoir right side up and slide into place
(Fig. 1e). The water level will equalize to approximately 1.27 cm
below the rim of the bowl.
Fig. 1d
9) Before you plug in the fountain make sure the cord and your
hands are dry. Plug the fountain in.
Set your desired flow rate with the flow
10)
control knob, located to the right of the
splash ramp. In the 10 o'clock position
for a smaller stream or in the 2 o'clock
position for a strong stream. (Fig. 1f)
11) Add water as needed. Do not let the water level fall lower
than the flow control knob or you may burn out the motor. Do
not pick up a full fountain by the filter housing. Only use the
handles located on the bottom of the bowl on either side of the
fountain.

www.petsafe.net
Fig. 1e
MIN
Fig. 1f
MAX