Laerdal Resusci Baby Mode D'emploi page 3

Power Supply
Four 1.5 V alkaline batteries, size C.
This will provide approximately 125 hours of use
in the classroom.This will vary depending on use
patterns and brand of batteries.
Changing batteries
When replacing worn out batteries in your
Skillguide Signal Box, we encourage you to
replace them with alkaline batteries.
To replace batteries:
1. Place your thumb on the marked area next
to the arrow.
2. Push firmly in the direction of the arrow to
slide open the battery cover.
3. Remove and discard old batteries.
4. Replace new batteries as indicated on
battery cover.
5. Align battery cover with grooves in battery
compartment.
6. Slide cover and snap closed.
Inflation volume:
Compression depth:
Wrong finger position:
Too fast inflation
1. Measurement tolerance in the manikin +/- 15% in normal
room temperature
2. If manikin is used in laboratory tests, remove pants for
accurate measurements
Light Indication
green correct
orange too much
green correct
orange too much
red Pressure outside
of acceptable area
red
Connection cable
This is permanently connected to the Skillguide
and has an 8 pin male connector which is to be
connected to the manikin.The connector has
been molded for proper orientation prior to
plugging it into the manikin's side.
Caution:
Make sure that the Skillguide is unplugged from
manikin:
- when airway is changed, or
- when internal service is carried out
1, 2
Measurement
30 ml
50 ml
.5 in (13 mm)
1.0 in (20 mm)
30 ml ≤ 0.27 sec
3