SPIDO GC-1100P/24B Mode D'emploi page 15

FEATURES / DETAILS
Suction line
1
Suction filter
2
Non-return valve (x2)
3
Pressure line
4
Shut-off cock
5
Suction port
6
Pressure port
7
Filling opening for water
8
Drain screw for water
9
Pump housing
10
Terminal box
11
Power switch
12
Armoured hose
13
Pressure switch
14
Pressure gauge
15
Pressure tank
16
Tank valve with protective cap
17
Carry handle
18
Main connection cable
20
Coarse filter
21
Coarse filter screw
22
Wrench for coarse filter
23
HA : Suction head (between the surface of water and the pump)
HI : Difference between surface of the liquid to be pumped and
entrance of the suction line (min 0.3m)
Please read through these operating instructions
carefully to make sure that you can fully benefit from
all features. Some explanatory illustrations can be
found at the end of these operating instructions.
We hope you will enjoy your new device !
TABLE OF CONTENTS
1. General safety information
2. Technical Data
3. Range of use
4. Scope of delivery
5. Installation
6. Electrical connection
7. Putting into operation
8. Setting the pressure switch
9. Operating the pump with a SPIDO prefilter
10. Maintenance and troubleshooting
11. Warranty - Service
Annex : Illustrations
GB