Rotel U7301CH Mode D'emploi page 20

 ASSEMBLING THE CASTORS
o
Carefully turn the radiator around so that you can easily mount the castors.
o
Insert the U-shaped bracket from below into the linking connection between the
first and the second, as well as between the last two fins.
o
Now secure the holder for the castors with two wing nuts on the U-bracket
 ELECTRICAL CONNECTION
o
Before plugging the plug into the socket, make sure that the voltage indicated on
the rating label of the unit is the same as that of the mains in your home, and that
the mains plug and power line are dimensioned according to the load required.
o
Please make sure that the plug socket used for the power is properly earthed.
 HOW TO USE AND OPERATE YOUR UNIT
o
Heating up: Put the plug in the socket.
 ADJUSTING THE TEMPERATURE
o
As soon as the temperature set on the unit has been reached in the room, turn the
thermostat knob slowly to the left until the indicator light goes out. The thermostat
will now automatically control and maintain the prevailing temperature of the
room.
Gebrauchsanweisung ○ Mode d'emploi ○ Istruzioni per l'uso ○ Instruction for use
Turn the thermostat fully to the right (maximum setting).
Buttons for the different heat settings:
- Off = both switches are off
- Level I = left switch "MIN I" on, min. power (600W / 800W)
- Level II = right switch "MID II" on, med. power (900W / 1200W)
- Level III = both switches "MAX" on, full power (1500W / 2000W)
The respective indicator lights will light up.
.