Setting Mode - AEG FAVORIT 65000 Notice D'utilisation

USING THE DETERGENT
A B
30
20
SETTING AND STARTING A
PROGRAMME

Setting mode

The appliance must be in setting mode
to accept some operations.
The appliance is in setting mode when,
after the activation:
• All the programme indicators come
on.
• The display shows two horizontal sta-
tus bars.
If the control panel shows other condi-
tions, press and hold Delay and Start
at the same time until the appliance is
in setting mode.
Starting a programme without
delay start
1. Press the release button (B) to
A
+ -
2. Put the detergent in the compart-
3. If the programme has a prewash
C
4. If you use detergent tablets, put
5. Close the lid. Make sure that the
1. Open the water tap.
2. Press the on/off button to activate
3. Close the appliance door.
4. Make sure that the appliance is in
5. Press Program again and again un-
6. If you want, you can set the options.
7. Press Start. The programme starts.
CAUTION!
Use only detergents for dish-
washers.
open the lid (C).
ment (A) .
phase, put a small quantity of de-
tergent on the inner part of the ap-
pliance door.
the tablet in the compartment (A).
release button locks into position.
Do not use more than the cor-
rect quantity of detergent. Refer
to the instructions on the deter-
gent packaging.
Detergent tablets do not fully
dissolve with short programmes
and detergent residues can stay
on the dishes.
We recommend that you use
detergent tablets with long pro-
grammes.
the appliance.
setting mode.
til the indicator of the programme
that you want to set comes on.
• The programme duration flashes
in the display.
• The phase indicators of the set
programme come on.
• Only the indicator of the phase in
operation stays on.
ENGLISH
35