Back Panel; Installation Requirements - FS S1900-16TP Guide De Démarrage Rapide

VLAN Mode:
In this mode, ports 1 to 14 are isolated from each other, but can communicate with ports 15 and
16 (uplink ports) respectively.
And the switch can reduce broadcast storm and isolate DHCP broadcast.
Isolation Mode:
In this mode, ports1 to 8 and ports 9 to 16 belong to two different VLAN.
This mode can be used to isolate supervision network and wireless network to make them not
interfere with each other.

Back Panel

Grounding Point

Installation Requirements

Before you begin the installation, make sure that you have the following:
Desktop mounting: ESD bracelet (or ESD gloves)
Wall mounting: ESD bracelet (or ESD gloves), ladder, marker, hammer drill, rubber hammer,
expansion bolts (M5*40mm), screws (PA5*25 mm, head diameter: 10 mm), screwdriver.
Rack mounting: ESD bracelet (or ESD gloves), Phillips screwdriver, M6 Screws, Standard-sized 19"
wide rack with a minimum of 1U height available.
Site Environment:
Do not operate it in an area that exceeds an ambient temperature of 40°C.
The installation site must be well ventilated. Ensure that there is adequate air flow around the
switch.
Be sure that the switch is level and stable to avoid any hazardous conditions.
Do not install the equipment in a dusty environment.
The installation site must be free from leaking or dripping water, heavy dew, and humidity.
Ensure rack and working platforms are well earthed.
AC 100-240V 56/60HZ
Power Supply
3