Front Panel - FS S1900-16TP Guide De Démarrage Rapide

Front Panel

1 3
PWR 2 4
S1900-16TP PoE+
PWR
LEDs Status
Solid on
PWR
Off
Solid on
RJ45 Blinking
Off
Solid on
PoE
Off
Network Mode Switch:
Set the network mode to the one you need using the network mode switch according to the
following description.
Standard Mode (default):
In this mode, the switch functions as a common switch and all the ports of the switch can
communicate with each other.
CCTV Mode:
In this mode, PoE ports 1-8 have higher priorities over the other ports. All the ports of the switch
can communicate with each other.
If multiple IP cameras are connected to the switch, you are recommended to enable this mode
and connect special supervision IP cameras to the ports with high priority the two uplink ports of
the switch to upstream devices (such as NVR, router, and so on), to ensure smoother monitoring
video playback.
Ports 15 and 16 are uplink ports.
2
Link/Act
5 7 9 11 13 15
PoE
Isolation
Link/Act
VLAN
6 8 10 12 14 16
PoE CCTV
Standard
RJ45/PoE Network Mode Switch
Description
The switch is connected to a power supply properly.
The switch is not connected to a power supply properly or
not connected to a power supply.
The port is connected properly.
The port is transmitting or receiving data.
The port is not connected properly or not connected to
a device.
A PD is connected to the PoE port and powered properly.
No PD is connected to the PoE port.
1 2 3 4 5 6 7 8 9
Isolation: Ports 1-8 are isolated with ports 9-16 VLAN: Ports 1-14 are isolation, but can link with ports 15-16
10 11 12 13 14 15 16