Switching Off The Alarm; Sleep" Function - Beurer WL 50 Mode D'emploi

Activating the snooze function
When the alarm sounds, touch the sensor surface (speaker surface on the top of the device) for
1 second to snooze the alarm. When snooze function is activated, a light red light appears. The
snooze duration is 8 minutes. After 8 minutes the alarm will sound again.

Switching off the alarm

When the alarm sounds, touch the sensor surface (speaker surface on the top of the device) for
3 seconds, or press the Alarm 1 or Alarm 2 button, to switch off the alarm.
If you touch the sensor surface, the alarm will go off automatically at the same time the following
day. If you press alarm Alarm 1 or Alarm 2 button, then the alarm won't go off any more. To acti-
vate the alarm, press the Alarm 1 or Alarm 2 button on the wake up light. Make sure that
is visible in the display. Only then will the alarm sound on the following day at the set alarm time.

7.3 "Sleep" function

The "Sleep" function is ideal for helping you fall asleep. A simulated sunset can be set here. With
this function, the light gradually dims after a set period of time. For added relaxation, you can
pair the simulated sunset with sounds of the sea, the radio or your own music.
To switch on the "Sleep" function on the wake up light, proceed as follows:
1. Select the desired musical accompaniment to falling asleep with the Mode button. If you do
not wish to have any musical accompaniment, skip this step.
= Music via Bluetooth
BLUE
= Radio
FM
®
39
or