Radio; Setting The Display Brightness; Aux Connection; Switching The Button Tone On/Off - Beurer WL 75 Mode D'emploi

7.6 Radio

Note
You can configure the radio settings using the "beurer
LightUp" app or the buttons on the wake up light.
Setting the radio station
To set the radio station using the buttons on the wake up
light, proceed as follows:
1. Press the Set button on the device twice. "SET Radio"
appears on the display. Wait three seconds until the
current station frequency flashes on the display.
2. Use the / buttons to set the desired radio station.
To start the station search, press and hold the
button. Confirm with the Set button.
3. Programme number P 01 flashes on the display. Use
the / buttons to select the desired programme
number (e.g. P 01 or P 02) under which the set ra-
dio station is to be saved. There are 10 radio memory
spaces available. Confirm with the Set button.
Switching the radio on/off
1. To switch the radio on or off, press the Radio button
on the wake up light.
2. To switch between the saved radio stations, first press
the Set button. Use the
sired radio station.
3. To set the volume, press the
radio is playing.

7.7 Setting the display brightness

Note
The wake up light has four display brightness levels (0,
1 , 2 and 3 ). You can set the display brightness in the
settings of the "beurer LightUp" app or using the but-
tons on the wake up light.
To set the display brightness using the buttons on the
wake up light, proceed as follows:
1. Press the Set button on the device four times. "SET
Display" appears on the display. Wait three seconds
until a number flashes on the display.
2. Use the / buttons to set the desired display bright-
ness. Confirm with the Set button. The configured dis-
play brightness is shown after 5 seconds.
Alternatively, you can also tap on the right-hand side of
the display to make the display brightness briefly brighter.
/ buttons to select the de-
/ buttons while the

7.8 AUX connection

You can connect an external audio source (e.g. MP3
player, smartphone or CD player) to the wake up light
via the AUX input.
1. Connect the supplied AUX cable to an audio source.
2. Insert the other end of the AUX cable into the AUX input
on the rear of the device.
3. Press the AUX button on the device. The external audio
source is now connected to the wake up light.
4. Use the /
5. Press the AUX button to exit AUX mode again.
or

7.9 Switching the button tone on/off

You can only switch the button tone of the wake up light
on and off via the settings in the "beurer LightUp" app.

7.10 Activating/deactivating Bluetooth

Note
The wake up light is supplied to the customer with Blue-
®
tooth activated. If you deactivate Bluetooth
up light cannot be connected to the "beurer LightUp"
app.
To deactivate Bluetooth
as follows:
1. Press the Set button on the device five times. "SET
appears on the display. Wait three seconds until "
flashes on the display.
2. Press the or
play. Confirm with the Set button. Bluetooth
deactivated on the wake up light.
15
buttons to adjust the volume.
on the wake up light, proceed
®
button until "OFF" appears on the dis-
®
®
, the wake
"
"
on
is now
®