HQ Power VDLC4000 Mode D'emploi page 2

4. Use
a. Front panel:
1. POWER SWITCH:
The GREEN LED lights up when the power is "ON".
2. OUTPUT FUSE HOLDER:
Each channel is provided with an output fuse (T6A/250V (order code FU6.3N))
3. CHANNEL 1 SELECTOR:
PRO: Controlled by program block.
LF: The low frequency of music signal controls the lighting of LEDs.
DIM: Controls the brightness trough the fader.
4. CHANNEL 2 SELECTOR:
PRO: Controlled by program block.
MF: The mid frequency of music signal controls the lighting of LEDs.
DIM: Controls the brightness trough the fader.
5. CHANNEL 3 SELECTOR:
PRO: Controlled by program block.
HF: The high frequency of music signal controls the lighting of LEDs.
DIM: Controls the brightness trough the fader.
6. CHANNEL 4 SELECTOR:
PRO: Controlled by program block.
REV: The LEDs light up when there is no incoming signal.
DIM: Controls the brightness trough the fader.
7. DIRECTION:
→ Direction: LED will run from channel 1 to 4 when selector is in PRO-position.
← Direction: LED will run from channel 4 to 1 when selector is in PRO-position.
8. RUN MODE:
Comes in 2 modes, flow light or static.
When the channel selector is in PRO-position, and flow function is used, one light dims slowly and the next
one gradually brightens up. If static function is used, one light goes off and the next one lights up.
9. CHASERS:
SOUND: The sound signal controls the brightness of the light when in PRO-position.
FULL: The sound signal does not control the brightness of the light.
10. PUSH / FLASH:
Each channel has this function. When the button is pressed, light brightens to 100% until push button is
released.
VDLC4000
2
Fig. 1
VELLEMAN