Customer Service; Replacing The Lamp - AEG AHB73721LW Notice D'utilisation

12 www.aeg.com
Problem
The compressor does not
start immediately after
pressing the FROSTMATIC,
or after changing the tem-
perature.
Temperature cannot be set.
The temperature in the ap-
pliance is too low/too high.

7.2 Customer Service

If your appliance is still not working
properly after making the above checks,
contact the nearest Authorised Service
Centre.
To obtain fast service, it is essential that
when you apply for it you specify the
model and serial number of your
appliance which can be found either on
the guarantee certificate or on the rating
plate located on the external right side
of the appliance.
Possible cause
The water drainage plug is
not correctly positioned.
Temperature is set incorrect-
ly.
This is normal, no error has
occurred.
The FROSTMATIC function
is switched on.
The temperature regulator is
not set correctly.
The lid is not closed correct-
ly.
The products' temperature
is too high.
Many products are stored at
the same time.
The thickness of the frost is
greater than 4-5 mm.
The lid has been opened of-
ten.
The FROSTMATIC function
is switched on.
Products to be frozen are
placed too closely to each
other.

7.3 Replacing the lamp

Solution
Position the water drainage
plug in the correct way.
Refer to "Operation" chap-
ter.
The compressor starts after a
period of time.
Refer to "FROSTMATIC
function".
Set a higher/lower tempera-
ture.
Refer to "Opening and clos-
ing the lid".
Let the product temperature
decrease to room tempera-
ture before storage.
Store less products at the
same time.
Defrost the appliance.
Open the lid only if necessa-
ry.
Refer to "FROSTMATIC
function".
Make sure that there is cold
air circulation in the appli-
ance.
The appliance is equipped
with a longlife LED interior
light.
WARNING!
Do not remove the lamp
cover at the time of
replacement. Do not
operate the freezer if the
lamp cover is damaged or
missing.