Spypoint SDB-85 Manuel De L'utilisateur page 13

24
PROGRAMMING
Turn on the device and navigate the interface by pressing the
"UP" or "DOWN" and pressing "OK" to choose an option.
Edit with "UP" or "DOWN" and choose "EXIT" or press "OK"
to confirm.
Start Enable the detection system. During startup, a delay of
30 seconds elapses before the device begins operation.
Mode Sets how the device plays the audio files.
Random: For each detection, the device randomly
chooses an audio alert from the available files.
Single: For each detection, the device uses the same
audio alert. When selecting this mode, the user must
define the file to use from the list of available sounds.
Delay Allow the user to choose the time interval before the
device can detect again.
Play Allow the user to listen the audio alerts available on
the SD card or on the device.
Test Allow the user to test the device to determine if it
detects properly at the desired location. When the
«Test» mode is selected, no audio alert is issued.
Walk perpendicularly in front of the device. When the
SDB-85 detects motion, the test light turns on to
indicate that the device would normally be triggered.
Language Select a language for the menu.
CONNECTION
1/8" mono audio output jack
Allow the user to connect the soundbox to an external speaker or
headphones. The internal speaker of the device is disabled when the
external jack is used.
1/8" mono input jack for external triggering
Allow the user to connect a closed loop contact to trigger the device.
Audio output 12 volt
TROUBLESHOOTING
The device triggers abnormally.
1. Rising sun or sunset may cause false detection. The device must
be reoriented.
2. Small animal may also cause false detection. Rise up the device.
3. Motion detector may sense animals through foliage.
4. The device must be set on a stable and immovable object. e.g.
large tree.
The device cannot play audio files from the SD card.
• Make sure that the audio files are in MP3 format and are stored at
the root of the SD card. Files saved in a folder or subfolder will
not be recognized by the device.
The red light in front of the device is blinking.
• The device is probably in startup mode and the light blinks for
30 seconds to allow the user to leave the premises without being
detected.
25
Mono input