Tornado 96190 Mode D'emploi page 6

SIDE ARM
ASSEMBLY
Operation
Controls
1. Pressure adjustment knob for Side Brush Used for setting of the side brush. The side brush
may touch the floor only by its one third section, so as to throw the swept matter into the machine.
The castor wheel is to keep the pre-set working height of the side brush.
2. Pressure adjustment knob for Main Brush Used for setting of the main brush pressure. The
pressure must be set so as to assure perfect cleaning operation.
3. Knobs Used to secure the handle to the machine or to reposition it.
Excess pressure will cause unnecessary wear of the brush and increased load for the
operator.
4. Main Brush Pressure Reading Scale Indicates the pressure at which the main brush has been
set. Setting must be performed as described below:
Set the main brush by turning the knob clock-wise to increase the pressure, at this position the scale
should read „5‟
Starting with this setting, the main brush pressure can be increased to meet the requirement. (As the
brush wears out)
Turn the knob in counter-clockwise direction to reduce the main brush pressure according to the task.
SIDE BRUSH
SUPPORT
6
FROM IDLER
PULLEY