Proper Use; Acceptance Of The Machine; How To Put The Machine Into Operation; Assembly - Tornado 96190 Mode D'emploi

Introduction

Proper Use

The unit has been exclusively designed for floor cleaning, such as dry sweeping .Whatever use be-
yond this specified use will be deemed improper use and the manufacturer cannot be held liable for
damages.
The term "proper use" also includes compliance with the manufacturer's instructions about operation,
maintenance and repair.
The unit must be serviced and repaired by an authorized service center. The appropriate safety pre-
cautions as well as applicable general regulations about safety and health at work should be com-
plied with.
Modifications made to the unit will relieve the manufacturer from liability and damages.
This machine is not suitable for evacuation of dust or dust particles, which
are explosive or otherwise dangerous to health.

Acceptance of the Machine

Upon receipt, check your machine for possible transit damage and contact your freight company if
you suspect damage.

How to put the machine into operation

Assembly

For ease of packing, the handle and side brush assembly are packed separately. These parts must
be installed before the machine is put into operation. The handle is mounted by means of knobs. The
handle can be fixed in two different positions as shown below.

Side Brush Assembly

1. Mount the side broom to the brush plate on the side arm assembly using hex head bolt and nylock
nut
2. Position the V-Belt from the side arm assembly around the pulley attached to the backside of the
right wheel. In order to do this it will be necessary to twist the V-Belt. The lower loop of the V-belt
should be coming from the idler pulley (not from the broom pulley).
3. Attach the side arm assembly to the support side brush on the frame by aligning the bushing in the
side arm with holes in the sides of the support side brush and inserting a pin. Secure the pin in place
by inserting a retaining ring into the groove in the pin.
4. Check for proper rotation and operation of the side broom. The broom should rotate counter clock-
wise when the sweeper is pushed forward-if not the V-belt was installed incorrectly. If the belt slips the
tension can be adjusted by loosening the 2 screws that attach the support side brush to the frame,
move the bracket forward, then re-tighten the screws.
5