Before First Use - Princess 282990 Mode D'emploi

General
With this attractive Princess Beer Tap &
Cooler you can tap the best tasting beer
yourself. At home, but also in the garden
for a barbecue or party. The cooler's
insulated wall ensure that the beer will stay
cold for hours, even without power. The
Princess Beer Tap & Cooler can dispense
Heineken 5 Litre Beer kegs or similar kegs
that utilises an internal carbonator that
releases carbon dioxide each time the tap
is opened. The princess Beer Tap & Cooler
is unfortunately not suitable for use with
gravity dispensed beer kegs.
As well as for tapping beer, you can also
use the Princess Beer Tap & Cooler for
keeping bottles of wine, and cans of beer
and soft drinks cool. Handy if you're on the
road.
The quality and performance of this Beer
Tap & Cooler in combination with the
Heineken 5 l keg is completely the
responsibility of Princess. The brewer is in
no way liable for this.
Operation
See Figure D-1.
The equipment consists of the following
parts:
1 Housing
2 Cover with hand grip
3 Seal
4 Tap unit
5 Tap handle
6 Extension pipe (5x)
7 Drip tray with grille
8 12 V DC cable
9 AC cable with plug
6 Beer Tap & Cooler Article 282990
See Figure C-1.
10 AC connection
11 12 V DC connection
12 On/Off indicator light
13 Supply voltage selector switch

Before first use

1 Remove all the packaging.
2 Clean the appliance and all accessories
(see 'Maintenance and cleaning').
Tapping beer
Position the keg
See Figures A-1 to A-3 and Figure C-1.
• The appliance's tap function is only
suitable for 5 litre kegs.
• Read and follow the instructions and
warnings on the keg before you place
it in the appliance.
• Ensure that the keg has been cooled
before placing it in the appliance.
• Always check that the use-by date on
the keg has not expired before placing
the keg in the appliance.
• Before using the appliance, check
whether the mains supply voltage
matches the voltage indicated on the
type plate of the appliance.
1 Position the green tap handle holder on
the keg.
2 Remove the grey pipe from the green
keg connection and replace this pipe
with the extension pipe from the Beer
Tap & Cooler.
3 Position the keb conection (including
extension pipe) in the green tap handle
holder. Ensure that the green tap
handle is folded fully backwards.
4 Position the tap unit on the keg. Ensure
that the green tap handle on the keg is
vertical and protrudes through the