Reely ROAD Leopard Notice D'emploi page 52

 The vehicle doesn't drive in a straight line correctly
• Set straight driving at the transmitter using the respective trimming control for the steering function.
• Check the steering rods or wheel alignment setting.
• Did your car have an accident? If so, check the vehicle for any defective or broken parts and replace them.
 Steering works opposite to the way the steering wheel is turned at the transmitter
• Put the reverse switch for steering into the correct position.
 Driving works opposite to the movement of the throttle/brake lever at the transmitter
Usually, the vehicle should drive forwards if you pull the throttle/brake lever at the transmitter towards the handle.
• Activate the driving reverse setting at the transmitter.
• If the brushless motor is disconnected from the speed controller and reconnected, the alignment of the 3 connection
cables between the motor and speed controller is not correct. Simply swap two of the three cables between motor
and speed controller. This reverses the rotational direction of the brushless motor (this may not be possible fort his
vehicle, because the cables are soldered-in and do not have any plug connection).
 The steering is not functioning or is functioning incorrectly, steering lock too slight on the vehicle
• If the transmitter offers a dual rate setting, check it (see operating instructions for the transmitter). If the dual rate
setting is too low the steering servo will no longer react.
The same applies for the so-called EPA setting (= "End-Point-Adjustment", setting of the end positions for the servo
path to protect the servo mechanism).
• Check the steering mechanism for loose parts, check e.g. whether the servo arm is correctly fastened to the servo.
 Reverse driving not possible
• Check the speed controller's programming to see of reverse driving is switched on or off.
52