Safety Recommendations; Eu Declaration Of Conformity - SKF TLGU 10 Mode D'emploi

Le contrôleur de lubrification à ultrasons
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Safety recommendations

Read this instruction for use fully. Follow all safety
precautions to avoid personal injury or property
damage during equipment operation. SKF cannot
be responsible for damage or injury resulting from
unsafe product use, lack of maintenance or incorrect
equipment operation. In case of any uncertainties as
regards the use of the equipment contact SKF.
Failure to comply with the following could cause
equipment damage and personal injury.
Do not expose the equipment to rough handling
or heavy impacts.
Always read and follow the operating
instructions.
Opening the housing of the instrument may
result in hazardous mishandling and voids
warranty.
The equipment should not be used in areas
where there is a risk for explosion.
Do not expose the equipment to high humidity
or direct contact with water.
All repair work should be performed by an SKF
repair shop.
Using any other headset than the one supplied
with the instrument can cause internal damage
to the checker.

EU Declaration of Conformity

TLGU 10
We, SKF MPT, Meidoornkade 14, 3992 AE Houten,
The Netherlands herewith declare
under our sole responsibility that the products
described in these instructions for use, are in
accordance with the conditions of the following
Directive(s):
EMC DIRECTIVE 2014/30/EU
RoHS DIRECTIVE (EU) 2015/863
and are in conformity with the following standards:
EN 61326-1:2013:
Electrical equipment for measurement, control
and laboratory use - EMC requirements -
Part 1: General requirements.
EN 55011: 2016 + A1:2017:
Industrial, scientific and medical (ISM) radio-
frequency equipment - Electromagnetic
disturbance characteristics - Limits and
methods of measurement.
EN 61000-4-2:2009:
Electromagnetic compatibility (EMC) -
Part 4: Testing and measurement techniques.
Section 2: Electrostatic discharge immunity test.
EN 61000-4-3:2006 + A1:2008 + IS1:2009
+ A2:2010:
Electromagnetic compatibility (EMC) -
Part 4: Testing and measurement techniques.
Section 3: Radiated, radio-frequency,
electromagnetic field immunity test.
Houten, The Netherlands, November 2021
Mrs. Andrea Gondová
Manager Quality and Compliance
3
EN

Publicité

Chapitres

Table des Matières
loading

Table des Matières