Resetting The Co Meter To Factory Settings - VOLTCRAFT CO-100 Notice D'emploi

i) Resetting the CO
This function resets the CO
Not only the threshold value settings, but also basic calibration is reset.
All 48 data memory slots (see chapter 9 g) are also deleted.
Proceed as follows:
• Briefly press the „MODE" button repeatedly (from the normal operating mode) until
„RcFS" flashes on the display („RcFS" = Recover the Factory Settings").
• Briefly press the button „ENTER"; the top display line shows „NO".
• Select between „NO" and „YES" using the arrow buttons „" or „".
„NO" = do not reset
„YES" = Reset to default settings
• Briefly press the „ENTER" button.
If you selected „NO", the CO
settings.
Selecting „YES" resets all settings to factory settings and deletes all 48 data memory
slots. Then the CO
Meter to Factory Settings
2
meter to factory settings.
2
meter returns to normal display without resetting factory
2
meter returns to normal display.
2
39