Commissioning; Inserting And Replacing The Batteries - VOLTCRAFT BS-350XIPSD Notice D'emploi

8. CommISSIoNINg

a) Inserting and replacing the batteries
Before you can use the product, you need to insert the batteries. 4 AA batteries are needed
for operation.
This description also applies if you have to replace the batteries later.
• First, open the battery lid of the
endoscope. It is located at the rear of
the main unit.
Open the two screws of the battery
compartment lid with a Phillips screw-
driver (see the two white circles in the
image) until they spin. They cannot be
removed entirely.
Now push the lever (white arrow in the
image) in the direction of the arrow.
At the same time, lift the battery com-
partment lid and take it off of the battery
compartment.
• If you want to replace the batteries,
remove the old batteries first.
• Then insert 4 new AA batteries into the battery compartment.
Please observe correct polarity (plus/+ and minus/-). How to insert the batteries is marked in
the battery compartment by illustrations.
• Last, close the battery compartment again.
For this, hook the lid at the top in the housing with both guides and fold it shut until the lever
latches at the bottom.
• Screw on the two Phillips-head screws hand-tightly again.
• This completes insertion or replacement of the batteries.
35