Displaying/Resetting Max/Min Values - VOLTCRAFT CO-100 Notice D'emploi

h) Displaying/Resetting MAX/MIN Values
In operation, the CO
enables, e.g., quick determination of peak loads.
This maximum and minimum memory can, of course, be reset.
Proceed as follows:
• Briefly press the „MODE" button repeatedly (from the normal operating mode) until
„MAX MIN" flashes on the display.
• Briefly press the „ENTER" button. The display now alternates between maximum and
minimum CO concentration values and the corresponding temperature / humidity.
2
• If the maximum and minimum value is to be reset, briefly press one of the arrows „"
and „", so that „CLR" appears on the display (press the arrow again to leave deletion
mode again).
Briefly press the „ENTER" button while „CLR" is displayed to reset the maximum and
minimum values to the current measured value. The CO
display.
The current measured value is displayed as the new maximum and minimum value
until another change happens.
• If the values are not to be reset, briefly press one of the errors. „CLR" disappears. Then
briefly press the „ENTER" button. The CO
38
meter stores the highest and lowest CO
2 2
meter returns to normal
2
meter returns to normal display.
2
value measured. This