Automatic Switch-Off; The Heat Setting; Automatic Heat Up - Electrolux GK58TSO Notice D'utilisation

4.2 Automatic Switch Off
The function deactivates the hob
automatically if:
• all cooking zones are deactivated,
• you do not set the heat setting after
you activate the hob,
• you spill something or put something
on the control panel for more than 10
seconds (a pan, a cloth, etc.). An
acoustic signal sounds and the hob
deactivates. Remove the object or
clean the control panel.
• you do not deactivate a cooking zone
or change the heat setting. After some
time comes on and the hob
deactivates.
The relation between the heat setting
and the time after which the hob
deactivates:
Heat setting
, 1 - 3
4 - 7
8 - 9
10 - 14

4.3 The heat setting

To set or change the heat setting:
Touch the control bar at the correct heat
setting or move your finger along the
control bar until you reach the correct
heat setting.
4.4 Activating and deactivating
the outer rings
You can adjust the surface you cook to
the dimension of the cookware.
Use sensor field:
The hob deacti‐
vates after
6 hours
5 hours
4 hours
1.5 hour
To activate the outer ring: touch the
sensor field. The indicator comes on.
To deactivate the outer ring: touch the
sensor field until the indicator goes out.

4.5 Automatic Heat Up

Activate this function to get a desired
heat setting in a shorter time. When it is
on, the zone operates on the highest
setting in the beginning and then
continues to cook at the desired heating
setting.
To activate the function the
cooking zone must be cold.
To activate the function for a cooking
zone: touch (
Immediately touch a desired heat setting.
After 3 seconds
To deactivate the function: change the
heat setting.
4.6 Timer
Count Down Timer
You can use this function to set how long
the cooking zone should operate for a
single cooking session.
First set the heat setting for the cooking
zone then set the function.
To set the cooking zone: touch
again and again until the indicator of a
necessary cooking zone comes on.
To activate the function: touch
the timer to set the time (00 - 99
minutes). When the indicator of the
cooking zone starts to flash slowly the
time counts down.
To see the remaining time: set the
cooking zone with
the cooking zone starts to flash quickly.
The display shows the remaining time.
To change the time: set the cooking
zone with . Touch
To deactivate the function: set the
cooking zone with
remaining time counts back to 00. The
indicator of the cooking zone goes out.
ENGLISH
comes on).
comes on.
of
. The indicator of
or .
and touch . The
9