Electrolux GK58TSO Notice D'utilisation page 72

Problem
An acoustic signal sounds
and the hob deactivates.
An acoustic signal sounds
when the hob is deactiva‐
ted.
The hob deactivates.
Residual heat indicator
does not come on.
Automatic Heat Up does
not operate.
You cannot activate the
outer ring.
There is a dark area
on the multiple zone.
The sensor fields become
hot.
There is no sound when
you touch the panel sensor
fields.
Possible cause
The fuse is blown.
You do not set the heat
setting for 10 seconds.
You touched 2 or more
sensor fields at the same
time.
Pause operates.
There is water or fat stains
on the control panel.
You put something on one
or more sensor fields.
You put something on the
sensor field .
The zone is not hot be‐
cause it operated only for a
short time or the sensor is
damaged.
The zone is hot.
The highest heat setting is
set.
It is normal that there is a
dark area on the multiple
zone.
The cookware is too large
or you put it too near to the
controls.
The sounds are deactiva‐
ted.
ENGLISH
Remedy
Make sure that the fuse is
the cause of the malfunc‐
tion. If the fuse is blown
again and again, contact a
qualified electrician.
Activate the hob again and
set the heat setting in less
than 10 seconds.
Touch only one sensor
field.
Refer to "Daily use".
Clean the control panel.
Remove the object from
the sensor fields.
Remove the object from
the sensor field.
If the zone operated suffi‐
ciently long to be hot,
speak to an Authorised
Service Centre.
Let the zone become suffi‐
ciently cool.
The highest heat setting
has the same power as the
function.
First, activate the inner ring
by changing the heat set‐
ting.
Put large cookware on the
rear zones if possible.
Activate the sounds. Refer
to "Daily use".
13