Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
8.3 Connection cable
• The hob is supplied with a connection
cable.
• To replace the damaged mains cable,
use the cable type: H05V2V2-F which
withstands a temperature of 90°C or
higher. Speak to your local Service
Centre.
8.4 Electrical connection
Install the hob with a socket supply line.
If there is no socket supply line, the fixed
home electrical system must include an
isolating device with at least a 3 mm-
contact separation to enable a
simultaneous and all-pole cut off from the
mains (according to NIN SEV 1000).
8.5 Attaching the seal to the
rabbet
1. Clean the rabbets in the worktop.
2. Cut the supplied seal stripe into 4
stripes. The stripes must have the
same length as the rabbets.
3. Cut the ends of the stripes at an
angle of 45°. They should fit in the
corners of the rabbets accurately.
4. Attach the stripes to the rabbets. Do
not extend the stripes. Do not bond
ends of stripes one over another.
After you assemble the hob, seal the
remaining gap between glass ceramic
and the worktop with silicone. Make sure
the silicone does not get under the glass
ceramic.
8.6 Attaching the seal
1. Clean the worktop around the cut out
2. Attach the supplied seal stripe to the
3. Add some mm when you cut the seal
4. Push the two ends of seal stripe
5. Fix the glass ceramic on the worktop
1
2
3
8.7 Assembly
1
2
3
1
2
3
1
2
3
area.
lower edge of the hob along the outer
edge of the glass ceramic. Do not
extend it. Make sure that the ends of
the seal stripe are located in the
middle of one side of the hob.
stripe to the length.
together.
with silicone.
min.
500mm
ENGLISH
15
min.
50mm
Publicité
Chapitres
Table des Matières
