Electrolux EKM3 Série Mode D'emploi page 9

• CAUTION: In order to avoid a hazard due to inadvertent resetting of the thermal cut-
out, this appliance must not be supplied through an external switching device, such as
a timer, or connected to a circuit that is regularly switched on and off by the utility.
• Do not use this appliance with multi- attachments at same time.
• Switch off the appliance and disconnect from supply before changing accessories or
approaching parts that move in use.
• UNPLUG FROM OUTLET WHEN NOT IN USE, BEFORE INSERTING OR REMOVING PARTS
AND BEFORE CLEANING.
TROUBLESHOOTING
PROBLEM
The motor slows down during
operation.
The appliance does not start.
The appliance vibrates/moves
during operation.
DISPOSAL
This symbol on the product indicates that this product contains a battery which shall not be disposed with
normal household waste.
This symbol on the product or on its packaging indicates that the product may not be treated as household
waste. To recycle your product, please take it to an official collection point or to an Electrolux service center
that can remove and recycle the battery and electric parts in a safe and professional way. Follow your
country's rules for the separate collection of electrical products and rechargeable batteries.
Electrolux reserves the right to change products, information and specifications without notice.
www.electrolux.com
POSSIBLE CAUSE
Amount of dough may exceed
maximum capacity.
Dough may be too wet, it sticks onto
the side of the bowl.
The appliance is not connected to
the mains.
The speed selector was not in "0"
position when the machine was
plugged and unplugged.
The blender is not fixed in the correct
position.
The rear attachment hub cover is not
in place or properly assembled.
The motor head is in the upper
position.
The suction feet are not fixed to the
surface properly.
It is normal for heavy loads (e.g heavy
dough, cheese).
SOLUTION
Remove half and process in two batches.
Add more flour, 1 tablespoon at a time until
the motor speeds up. Process until dough
cleans the side of the bowl.
Make sure to plug in the appliance before
operation.
Turn the speed selector to "0" position, and
then to the desired speed.
The blender handle should point towards
the back of the machine when properly
fixed.
Attach the rear attachment hub cover by
pushing it straight forward until locked into
position.
Set the speed selector to "0". Tilt the motor
head down. Move the speed selector from
"0" to desired speed (1-6).
Make sure the suction feet are clean.
Place the machine on a smooth and shiny
surface.
Remove half and process in two batches.
GB
FR
AR
BG
CZ
DE
DK
EE
FA
FI
HR
HU
IT
LT
LV
NO
PL
RO
RS
RU
SE
SI
SK
TR
UA
9