Control Panel - Franke FCBU 1204 C Mode D'emploi Et Installation

USE
Button Led Function
L - Turns the lights ON/OFF at maximum strength.
Press and hold for approx. 2 seconds to turn the lighting system on and off at reduced intensity.
T1 Fixed Turns the motor on/off at speed one.
Delay function:
Press and hold the button for approx. 3 seconds to Activate/Deactivate the Delay function
(automatic switching off of the Motor, the Fans and the Lighting with a 30' delay).
Cannot be enabled when Intensive or 24h are on.
T2 Fixed Turns the Motor on at speed two.
Press and hold the button for approximately 5 seconds, with all the loads turned off (Motor and Lights),
to turn the Activated Charcoal Filter alarm on. The relevant LED flashes twice to confirm.
To turn the alarm off, press the button again and hold for at least 5 seconds. The relevant LED flashes
once.
T3 Fixed Turns the Motor on at speed three.
Press and hold the button for approximately 3 seconds, with all the loads turned off (Motor and Lights),
to perform a reset. The LED S1 flashes three times.
T4 Fixed Turns the Motor on at INTENSIVE Speed.
This speed is timed to run for 6 minutes. At the end of this time, the system returns automatically to the
speed that was set before. If it is activated with the motor turned off, it will switch to OFF at the end of
the time.
Press and hold for 5 seconds to enable the remote control, indicated by the LED flashing twice.
Press and hold for 5 seconds to disable the remote control, indicated by the LED flashing just once.
S1 Fixed Signals the Metal Grease Filter saturation alarm, indicating that it is necessary to wash the filters. The
alarm is triggered after the Hood has been in operation for 100 working hours. (Reset see the parag.
Maintenance)
Flashing When this is activated, it signals the Activated Charcoal Filter saturation alarm, indicating that the filter
must be changed; the Metal Grease Filters must also be washed. The Activated Charcoal Filter satura-
tion alarm comes into operation after the Hood has been working for 200 hours. (Activation and Reset
see the parag. Maintenance)
EN
L T1 T2 T3

Control panel

S1
T4
9 9