Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
USE
Button Function
A
Turns the suction motor on and off at speed one.
B
Decreases the working speed.
C
Increases the working speed.
D
Activates Intensive speed from any other speed,
including motor off. This speed is set to operate for 6
minutes, after which the system returns to the speed
that was set before. Suitable to deal with maximum
levels of cooking fumes.
Press and hold the button for approximately 5
seconds, with all the loads turned off (Motor and
Lights), to turn the Activated Charcoal Filter alarm
on/off.
E
24H function
Turns the motor on at speed one and effects one 10
minute extraction every hour.
When the filters alarm is triggered, the alarm can be
reset by pressing and holding this button for
approximately 3 seconds.
These indications are only visible when the motor is
turned off.
F
Delay function
Activate automatic switch-off with a 30' delay.
Suitable to complete elimination of residual odours. It
can be activated from any position and is deactivated
by pressing the button or turning the motor off.
Press and hold the button for approximately 5
seconds, with all the loads turned off (Motor and
Lights), to turn the Remote control on/off.
G
Turns the lighting system on and off at maximum
intensity.
Press and hold the button for approximately 2
seconds, turns the lighting system on and off in
Courtesy Light mode.
H
Activates / Deactivates the Anti-condensation heating
elements(heating in 10 minutes).
EN
All manuals and user guides at all-guides.com
Control panel
Display
Displays the set speed
Displays the set speed
Displays the set speed
Displays HI and the time remaining alternately, once a
second.
FC+Dot (Flashes twice)-Alarm Activated.
FC+Dot (Flashes once)-Alarm Deactivated.
Displays 24 and the dot at the bottom right flashes
once a second, while the motor is running.
It is disabled by pressing the button.
FF flashes three times.
When the procedure terminates, the indication shown
previously turns off:
FG indicates the need to wash the metal grease filters.
The alarm is triggered after the Hood has been in
operation for 100 working hours.
FC indicates the need to change the activated charcoal
filters, and also to wash the metal grease filters. The
alarm is triggered after the Hood has been in operation
for 200 working hours.
Displays the operating speed and the dot at the bottom
right flashes once a second.
IR+Dot (Flashes twice)-Alarm Activated.
IR+Dot (Flashes once)-Alarm Deactivated.
-
-
The corresponding symbol flashes.
1 10
Publicité
Table des Matières
