Control Panel - Franke FSW 908 TC Mode D'emploi Et Installation

USE
A B C
Button Function
A Door Closed: Press and hold for approximately 2 Sec-
onds to open the door and turn the motor on at the last
speed set.
Door Open: Press briefly to turn the motor Off or On.
B Decrease the working speed.
C Increase the working speed.
D Can only be activated with Door Open. This speed is
timed to run for 10 minutes. At the end of this time the
system will automatically return to the speed set before.
Suitable to deal with maximum levels of cooking fumes.
E Can only be activated with Door Open. Starts the Motor
at a speed that allows suction of 100 m3/h. Cannot be
activated if Intensive or Delay are active.
F Can be activated with motor on (except for intensive and
24 mode). Activates automatic shutdown of the Motor
and the Lighting with a 30' delay.
G Performs a Reset of the Filter saturation alarm when the
button is pressed for approximately 3 seconds when all
the users (motor + lights) are turned off.
H Modifies the intensity of the Lighting each time the But-
ton is pressed, with a maximum of 5 levels, accessed in
cycle.
I Door Closed:
When pressed and held for approximately 2 seconds
opens the door half way and turns the lighting on to
maximum intensity. The intensity can be modified using
button H.
- When the button is pressed again, the lighting turns off
and the door closes.
- Press L for door fully open, motor at speed three and
lighting on.
- Press A for lighting off and door closed.
Door Open: Press briefly to turn the lighting On
or Off.
L Door Closed: Press and hold for approximately 2 Sec-
onds to open the door, turn the motor on at speed three
and turn the lighting on at maximum intensity.
Door Open: When pressed and held for approximately 2
seconds turns off the motor and the lighting, cancelling
any function that may be active and closing the door.
Keyboard Lock: it is possible to lock the keyboard, for example when cleaning the Glass, when the Hood has Motor and
Lights turned off and when no alarms have been triggered, either with the door open or closed.
Press F (Delay) for approximately 5 Seconds to enable or disable the Keyboard Lock, which is always confirmed by a
Beep and an animation on the display motor bar.
EN
All manuals and user guides at all-guides.com

Control panel

E
D
F
G
H
Display
Displays the set speed.
The number of lighted segments decreases.
The number of lighted segments increases.
The indicator I flashes and all the segments
on the Display are lit.
It is disabled by pressing the Button.
Displays 24 and the segments on the Display
all light up and then turn off one at a time in
cycle.
It is disabled by pressing the Button.
Displays a flashing Clock symbol.
It is disabled by pressing the Button.
After 100 hours in operation the Drop sym-
bol is displayed to indicate saturation of the
Metal Grease Filters.
After 200 hours in operation the letter C is
displayed to indicate saturation of the Acti-
vated Charcoal filters.
L
I
2
20
0