Bresser NightSpy 3x42 Mode D'emploi page 13

Masquer les pouces Voir aussi pour NightSpy 3x42:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

STORAGE
Always store the NightSpy 3x42-II (in its case) in a dry, well
ventilated area away from heating/air conditioning vents or other
heating devices. Temperature should not be lower than +10°C.
Remove the battery if the device is to be stored for longer than
2 months.
TROUBLESHOOTING
• The NightSpy 3x42-II does not work: Make sure that the
batteries are installed properly and that they are in good working
condition. Depress the "ON" switch to start the NightSpy 3x42-
II charging system.
• Condensation collects on the unit: Your NightSpy 3x42-II can
be used in extremely cold temperatures. However, when the
unit is brought back into a warm environment, you must wait
approximately 5 HOURS before using the unit. This is due to
condensation that may accumulate on the electronic circuitry.
• I cannot focus the NightSpy 3x42-II: Adjust the objective
lens and eyepiece according to the instructions listed in the
Operation section of this manual. If the NightSpy 3x42-II still
does not focus - clean the optical parts thoroughly - they may
be fogged or dirty.
TREATMENT OF OLD BATTERIES
Batteries do not belong into standard waste. As consumers you
are legally obligated to return used batteries. You can deliver your
old batteries to the public collecting points of your municipality or
everywhere, where batteries of this type are sold.
Batteries containing harmful agents are labelled like this:
Pb = Battery contains lead
Cd = Battery contains cadmium
Hg = Battery contains mercury

Publicité

Table des Matières
loading

Table des Matières