Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
• Your NightSpy 3x42-II was designed to be self-contained. Do
not open the body of the scope or otherwise attempt to service
this device.
• Always store the NightSpy 3x42-II in a dry, well-ventilated
room.
• Keep the NightSpy 3x42-II away from any heating and air con-
ditioning vents or other heating devices, direct sunlight, and
moisture.
• Avoid dropping or otherwise shocking the unit. Although
designed for rugged outdoor use, the NightSpy 3x42-II incorpo-
rates a sophisticated optical system which could be damaged
in extreme cases of misuse.
• Clean optical parts (lenses) with professional lens cleaning sup-
plies designed for use with multicoated optics.
• Clean the exterior of your NightSpy 3x42-II with a soft, clean
cloth.
Damage to this device from failure to observe these
warnings may void the NightSpy's warranty!
BATTERY INSTALLATION
To install, unscrew the battery compartment cover (6), insert
the battery (CR123A) into the battery compartment so that the
positive (+) and negative (-) terminals of the battery match the
markings inside the compartment, replace the battery cover care-
fully. Do not over tighten.
USING THE NIGHT SPY
After installing the battery the NightSpy is ready for use. Please
keep the following points in mind:
• Move into a dark area before activating the NightSpy 3x42-II
light amplifier.
• Remove the lens cap (5) and store in pocket provided.
• Activate the device by pushing the „ON" button (1).
• If the subject to be viewed is in a complete dark area, including
Publicité
Table des Matières
