Other Applicable Documents; Safety Instructions; Product Description; Functional Description - Rittal CMC III Mode D'emploi

EN
Notes on documentation, Safety instructions, Product description
1 Notes on documentation
This Installation and Short User Guide is intended for experienced, trained specialists and contains only
EN
the most important information concerning the assembly, installation and function of the CMC III leak
sensor, 15 m (subsequently referred to as the leak sensor).
1.1

Other applicable documents

CMC III leak sensor, 15 m assembly and operating instructions.
They are available at www.rittal.com and contain comprehensive application-relevant information and
technical data for the leak sensor with regard to:
– Other assembly options
– Functions
– Configuration options
– Detailed operating instructions
– Troubleshooting
2

Safety instructions

– Assembly and installation of the leak sensor may only be performed by experienced trained special-
ists.
– The leak sensor housing must not be opened.
– The electronic unit in the leak sensor must not come into contact with water, aggressive or flammable
gases and vapours.
– The leak sensor must only be operated within the specified environmental conditions (see
section 3.4).
3

Product description

3.1

Functional description

The leak sensor monitors the floor of the room for liquids (leaks) over the entire length of the sensor
cable, apart from a 2.5 metre (approximate) section at the connection end of the sensor cable, where
no leaks are detected. If a liquid is detected, the leak sensor reports this to the connected CMC III PU.
It contains an identifier that allows it to be detected automatically by the CMC III PU.
3.2 Proper use
The CMC III leak sensor monitors the floor of the room for liquids (leaks). It must only be used together
with the CMC III PU. Any other use is not permitted.
3.3 Scope of supply
– CMC III leak sensor, 15 m
– Accessories supplied loose (fig. 1)
– Installation and Short User Guide
3.4

Operating conditions

The leak sensor may only be operated under the following operating conditions:
Operating condition
Operating temperature range:
Humidity range:
Protection category:
8
CMC III leak sensor, 15 m
0 °C...+55 °C
5%...95% relative humidity, non-condensing
IP 30 to IEC 60 529
Rittal CMC III leak sensor, 15 m