Rittal CMC III Mode D'emploi page 10

Installation and operation, Service
Status change display on the multi-LED of the processing unit:
– Continuous green light: All devices connected to the CAN bus have the status "OK".
EN
– Continuous orange light: At least one device connected to the CAN bus has the status "Warning".
– Continuous red light: At least one device connected to the CAN bus has the status "Alarm".
Status change display on the multi-LED of the leak sensor:
– Continuous blue flashing: Communication via the CAN bus.
– Green flashing: When the measured value changes or, at the latest, every 5 seconds.
– Continuous red flashing: The leak sensor has "alarm" status.
– Continuous red light: Invalid measured value.
If installation was unsuccessful: see section 1.1.
Note:
Connection cables in various lengths can be purchased from Rittal.
5.3 Settings
The following parameters can be set or viewed at the CMC III PU website:
– DescName: Specific description of the leak sensor.
– Position: Sensor cable zone (zone 1 to zone 5) where the leak was detected.
– Delay: Time delay after which the status message changes.
– Status: Current status of the leak sensor, taking account of the delay value.
Note:
The zones specified on the website are intended as a rough indication of the leak area.
Because liquids vary, a precise specification of the leak area cannot be given.
For any software updates required, please visit www.rittal.com or contact Rittal Service (see section 6).
6 Service
For technical queries, please contact:
Tel.: +49(0)2772 505-9052
E-mail: info@rittal.de
Homepage: www.rittal.com
For complaints or service requests, please contact:
Tel.: +49(0)2772 505-1855
E-mail: service@rittal.de
10 Rittal CMC III leak sensor, 15 m