Display Information - Hendi 208953 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 114

9. DISPLAY INFORMATION

• This chapter will instruct you the information shows on the screen
and the solutions.
EMPTY TRAY
EMPTY GROUNDS
FILL WATER TANK
FILL BEANS
FILL POWDER
INSTALL TRAY
UNIT EMPTY
TEMPERATURE HIGH
TEMPERATURE LOW
ERROR 1
PRESSURE HIGH
VALVE RESET
RESTART MACHINE
Causes
If the water drip tray is full, any function
of making beverage will be out of service.
If the coffee grounds container is full,
any function of making beverage
will be out of service.
If water in the water tank is used up,
any function of making beverage
will be out of service.
If coffee beans in the bean container are
used up, function of making coffee
will be out of service.
There is not enough coffee powder
in the powder container.
The drip tray is not installed correctly;
any function is out of service.
The water in the pipe inside the machine
is not enough; any function is out of
service.
Temperature of the machine is too high,
the machine cannot be used.
Temperature of the machine is too low,
the machine cannot be used.
The coffee machine failures,
may not be able to be used.
1. Using dark roasted coffee beans
or over fine coffee powder;
2. The filter of the brewer is clogged.
Dispenser valve is blocked.
Solutions
Take the drip tray out, empty the
waste water in the drip tray and
reinstall it to the machine.
Take the coffee grounds container
out, empty the coffee grounds
container and reinstall it.
Fill the water tank with water.
Add beans into bean container,
and press the rotary button to release.
Next time when making coffee with coffee
powder, please put a full spoon of powder.
Install the drip tray correctly.
Press the rotary button to release,
to run the water replenishing system.
Power off the main power, and use
it 1 hour later.
Increase environmental temperature
to above 10°C.
1. Power off, restarting up;2. If still
unresolved, please pull out the plug.
Contact with customer sevice center.
1. Adjust grinder wheel to rougher;
2. Start brewer cleaning procedure
(refer to P17).
Restart coffee machine.
EN
25

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

208984

Table des Matières