Replacing The Crossfader; Replacing The Channelfader; Only Dn-X900 : Flex Fader Crossfader Slide Torque Adjustment Procedure - Denon DN-X500 Mode D'emploi

REPLACING THE CROSSFADER

6
The Crossfader may be removed without disassembly of DN-X500 and DN-X900 itself.
1. Pull out the crossfader knob.
2. Removed the two outer screws attaching the crossfader plate.
A
3. Remove the two screws attaching the crossfader bracket assembly from chassis.
B
4. Pull the crossfader bracket assembly forward and unplug the 3P cable from the connector on the panel board.
A
B
REPLACING THE CHANNEL FADER
7
The Channel fader may be removed without any disassembly of the DN-X500 and DN-X900 itself.
1. Pull out the channel fader knob.
2. Remove the two outer screws A attaching the channel fader plate and channel fader bracket assembly from the front panel.
3. Pull the channel fader bracket assembly forward and unplug the 3P cable from the connector on the channel fader printing
board.
4. Install the replacement assembly by reversing above instructions.
A
ONLY DN-X900 : FLEX FADER CROSSFADER SLIDE
8
TORQUE ADJUSTMENT PROCEDURE
1. Follow the procedure at "REPLACING THE CROSSFADER" to remove the crossfader from the set.
2. Move the lever so that the head of the screw is positioned at the hole in the case.
3. Turn the screw using a screwdriver, move the lever and adjust to the desired torque.
4. Reinstall the crossfader following the removal procedure in reverse order.
6
ENGLISH
ENGLISH