Thank you for choosing this GYS product; please read this instruction manual carefully before installing and using the
product, and keep in a safe place for future reference.
This product has been designed to carry out the following operations in a car body workshop:
Dent pulling; welding of nails, rivets, rings and pins; removal of bumps and dents; sheet stretching. It is not designed for
the assembly of metal parts.
ELECTRICITY SUPPLY
Single phase supply 230V 50Hz. 16A Circuit breaker curve D 16 A aM.
NB: If the product trips the circuit breaker, please check that the correct fuse and an adequate circuit
breaker are being used.
These are A-class devices. They are designed to be used in an industrial or professional environment. In a different
•
environment, it can be difficult to ensure electromagnetic compatibility, due to conducted disturbances as well as
radiation.
From 1st December 2010, the new standard EN 60974-10 will be applicable: Warning: these materials do not comply
•
with IEC 61000-3-12. If they are to be connected to a low-voltage main supply, it is the responsibility of the user to
ensure they can be connected. If necessary consult the operator of your electrical distribution system.
Use of the aluminium generator: The COMBI 230 E PRO protects itself if the voltage exceeds 265V. The device
prevents the charge of the capacitors. To indicate the failure, the 3 horizontal segments in the centre of the display light
up.
Charge of the capacitors: A blinking display indicates that the COMBI 230 EPRO is charging the capacitors to the
setpoint. 'DEF' indicates that there is a capacitors charge fault. Switch off and relight the machine. If the message persists,
please contact after sales service department.
OPERATING AND SETTING (FIG I-II P.2)
SWITCH with 3 positions: Aluminium/OFF/Steel:
Alu / Off / Steel
Alu
New generation dent puller 2 in 1. The GYSPOT Combi 230 E PRO is a dent puller for steel and aluminium car bodies. Cost-
effectiveness and time saving is provided by this method of repair by pulling single-point and multi-points without
disassembly.
This device contains 2 dent-pullers with two control panels:
A steel dent puller
Generator with multi-function guns and an earth cable.
- The gun with trigger connects to terminal no.5 ; the
command cable connects to terminal no.4
- The automatic gun (no trigger) connects to terrminal no.6
-
The earth cable is fixed on position no. 7
Steel
An aluminium dent puller
Capacitor discharge generator, with one gun equipped
with an earth adapter (3 brass terminals)
- The gun connects to terminal no.2
- The command cable connects to terminal no.1
- The earth cable connects to terminal no.3
8