Sony MDS-JE530 Mode D'emploi page 44

Using a Timer
Make sure to change the deck to standby status
within a week after timer recording is
completed.
The TOC on the MD is updated and recorded contents are
written to the MD when you turn the deck on. If the
recorded contents have disappeared, "Initialize" flashes
when you turn the deck on.
Notes
• It may take about 30 seconds after the deck is turned on until
recording starts. When recording at a specified time using the
timer, be sure to take this time into account when setting the
recording start time.
• During timer recording, new material is recorded from the end
of the recorded portion on the MD.
• Material recorded during timer recording will be saved to the
disc the next time you turn the deck on. "TOC Writing" will
flash in the display at that time. Do not disconnect the mains
lead or move the deck while the indication flashes.
• Timer recording will stop if the disc becomes full.
44
GB