patura P4500 Mode D'emploi page 61

Communication between energiser and remote control
The P4600/P6000 will only accept commands from a remote control handset when the remote
control feature is activated on the energiser. As a rule it is pre-programmed at the factory. In
case this did not happen it has to be activated one time only. The energiser and the remote
control will only communicate when both are set to the same address setting.
Activating the energiser for use with a remote control
To find out if the remote control feature is activated on the energiser:
1. Move the switch of the energiser to
desired position.
2. Wait for the display of the output voltage.
3. A blinking arrow at the right of the display indicates that the remote control feature is not
activated.
4. If the arrow at the right of the display is continuously lit, the remote
control feature is activated. Meanwhile the arrow at the right of the
display flashes.
To activate the remote control feature on the energiser:
Note: The energiser's remote control feature can be only be activated during the first 10
minutes of operation.
1. Ensure the code of the remote control is set to 1 (refer to the operating instructions of the
remote control handset for more information).
2. Move the switch of the energiser to
desired position.
3. Wait for the display of the output voltage.
4. Press to turn on the remote control handset
5. Hold the remote control handset within 5 to15 cm of the energiser and press
energiser will stop pulsing and the word "OFF" will appear in the top part of the display.
The arrow on the right of the display will stop flashing and remains continuously lit.
6. Turn off the energiser completely with the switch on
Changing the Address setting
You may want to change the address setting of your energiser:
• If you are using more than one remote-controlled energiser on your property and you want
each remote control handset to operate one energiser only or in reverse when you want
one remote control handset to operate more than one energiser.
. Wait 5 seconds and switch it back on to the
. Wait 5 seconds, and switch it back on to the
setting.
- 61 -
Arrow
. The