Mounting The Legs And Ash Drawer - Dovre 300CB Installation Et Mode D'emploi

2. Push the plate upwards so that you can tip it dia-
gonally (2).
3. Lower the plate to the bottom in the space (3).
4. Remove the plate from the appliance using the
door (4).
5. Repeat instructions (1) to (4) for the two remaining
plates.
Sides of inner plates
1. For both sides, slide the front inner plate forwards
as far as possible (1); see following figure.
1
5
3
2. Push the second plate up a bit (2) and tip it dia-
gonally (3) and (4).
3. Remove the plate from the appliance through the
door (5).
4. Remove the third plate in the same way as the
second one by repeating instructions (2) and (3).
5. Slide the first plate into the position of the second
plate and remove it in the same way.
Baffle plate (chimney pipe plate)
1. Take off the back cover (1); see following figure.
You now have access to the combustion area
from above.
6
2
4
09-20020-176
3
4
2. Detach the baffle plate at the back by unscrewing
the M8 screw (13mm) (2).
3. Lift up the baffle plate from the back.
4. Tip and lower the baffle plate (3).
5. Remove the plate from the appliance using the
door (4).
Mounting the legs and ash
drawer
Fit the legs to the appliance; see the following figure.
1. Tip the stove from the side.
2. Fit the four legs on the bottom plate using the was-
hers and the M8 nuts that are found on the bottom
plate.
Subject to change because of technical improvements
1
2
09-20020-177
09-20020-165