Technical Data; Trouble Shooting Guide - Titanium Speedline A3 6R Guide D'utilisation

11. Technical data

Type of laminating:
Maximum width:
Pouches:
Laminating pouch thickness
Warm-up time:
Heating system
Temperature controller:
Temperature regolator
Maximum speed:
Speed regulator:
REVERSE function:
Power
Dimensions:
Weight:

12. Trouble shooting guide

Problem
Machine has no power or
rollers are not rolling.
Excessive noise
Bad lamination
No increase of Temp.
Frequent curling of film
Corner is not sealed
Emergenza.
Cause
• Power code is not properly plugged in
• Power switch off
• Operation of gear is not smooth.
• Laminated document wrinkled, damp,
or folded.
• Check power plug.
• 1) check the film was cut off or the
un-adjoined side was inserted first
• 2) check the cleaning of rollers.
• Document is too thick to seal the edges
of the film.
• Something may be stuck Between
the heated rollers or they are out of
position.
Speedline A3 6R
hot/cold
max 335mm
max size A3
2x175 mic
5 min
6 heating rollers
0~140°
yes
1350mm/min
yes
yes
1050W
535x270x140mm
16,1kg
Solution
• Check the power plug is properly plugged
• Check the power switch is turned on
or contact support.
• Turn off the machine, and then contact
A/S.
• Adjust the000 temperature lower or
higher.
• Check if the power plug and switch is
turned on or contact support.
• Insert film by the sealed direction.
• Clean the rollers regularly.
• Use a thinner document or leave more
around the edges, aprox. 5mm
• Turn off the switch.
• Contact A/S.
27