Cleaning - Titanium Speedline A3 6R Guide D'utilisation

After the roller cool down, there will be beep sound for 5 times and then
power will be stopped automatically. si spegnerà automaticamente.
7. Cold lamination: press COLD button. -When the "READY" lamp indicates on LCD with
"beep" sound, user can start to perform laminating. (User can use cold film only.)
-If user afraid to damage on material, should use COLD lamination.
When using the laminator, a slight odour may be produced.
Ensure there is sufficient ventilation in the room, e.g. by opening windows.

7. Cleaning

Burn hazard!
The laminator will become hot during operation.
− Always let the laminator cool off completely before you clean it.
Risk of short circuit!
Water that has penetrated the housing may cause a short circuit.
− Never submerge the laminator in water.
− Make sure that no water penetrates the housing.
Risk of damage!
Water that has penetrated the housing may cause a short circuit.
− Never submerge the laminator in water.
− Make sure that no water penetrates the housing.
1. Disconnect the mains plug before cleaning.
2. Let the laminator cool off completely.
3. Use a damp cloth to wipe off the laminator. Let all parts dry completely afterwards.
Speedline A3 6R
25