Titanium Speedline A3 6R Guide D'utilisation page 20

you can quickly disconnect it from the mains in case of a failure.
− Do not operate the laminator if it is visibly damaged or if the
mains cord or mains plug is defective.
− If the mains cord of the laminator is damaged, the manu-
facturer, its customer service team or a person with similar
qualifications must replace it.
− Do not open the housing; instead, have a qualified professi-
onal perform the repairs. Contact the service address provided
on the warranty card. Liability and warranty claims are waived
in the event of repairs or conversions performed by the user,
improper connection of the device or incorrect operation.
− Only parts that comply with the original device data may be
used for repairs. Electrical and mechanical parts, which are
essential for providing protection against sources of danger, are
located in this laminator.
− Do not operate the laminator with an external timer or separate
telecontrol system.
− Do not immerse the laminator or the mains cord or mains plug
in water or other liquids.
− Never touch the mains plug with damp hands.
− Do not perform any other work (such as cleaning) on the
laminator while it is operating.
− Never pull the mains plug out of the socket by the mains cord;
instead, always do so by taking hold of the mains plug.
− Never use the mains cord as a carrying handle.
− Keep the laminator, mains plug and mains cord away from open
flames and hot surfaces.
− Lay the mains cord so that it does not pose a tripping hazard.
− Do not kink the mains cord and do not lay it over sharp edges.
− Never store the laminator so that it is at risk of falling into a bath
tub or washbasin.
− Never reach to retrieve the laminator if it has fallen in water. In
such a case, immediately disconnect the mains plug.
20
Speedline A3 6R