Assembling The Hood - Brandt BHB6602X Guide D'utilisation

2 / INSTALLING YOUR APPLIANCE EN
• •

ASSEMBLING THE HOOD

Warning
The hood must be installed in compli-
ance with all applicable regulations concern-
ing the ventilation of premises. In France
these regulations are described in DTU 61.1
from the CSTB. In particular, the evacuated air
should never be conveyed to a duct used to
evacuate smoke from appliances that use gas
or other combustible fuels. Unused ducts may
only be used after approval from a competent
Pic 3
specialist.
The minimum distance between the cooking
surface and the lowest part of the hood must
be 70 cm at least. If the instructions for the hob
installed under the hood specify a distance of
more than 70 cm, this requirement must be
respected.
Fixing to the wall:
F
- Draw a vertical line on the wall centered on
the cook top.
Pic 4
- In a suitable position, drill 3 holes and Insert
the 3 wall plugs for the hook. Drill 2 holes and
insert the 2 wall plugs for the inside chimney
bracket (Pic 3)
- Screw the hook to the wall with 3 screws.
Screw the inside chimney bracket to the wall
with 2 screws. Ensure they are perfectly
leveled. (Pic 3)
- Insert the extension tube. (Pic4)
- Hang the motor unit in the hook (Pic 5) and
fix the motor unit with 2 safety screws (Pic 6)
Pic 5
Pic 6
57